Thursday, February 3, 2011

Some corrections from rebuilding No 2

I have just finished rebuilding a second R1155B. It is now working successfully as a communications and DF receiver. But in the course of rebuilding I found a couple of errors still lingering.

The first is a missing wire from the bias tag board to V8 pin 6, here is the corrected page.



Then I missed a resistor R22 on the base of V8 from pin 6 to pin 8. Here it is:



Finally, one of my earlier corrections is wrong. I had the two wires from capacitors C23 and C24 on the end of the coil box going to the bias tag board. They should have gone to the 9-way tag board pins 8 and 9 as shown here.

No comments:

Post a Comment